Country-
spec. Set-
tings
Men
u
level
Display/
Setting
Action in this menu/meaning
4
1
2
3
4
Min. cos-phi Q1 - Min.
cos-phi Q4
NOTE: In the event of a significant voltage deviation, the max-
imum reactive power adjustment range can be limited by a
minimum cos φ in order to prevent an excessive reactive
power supply and, as a result, a significant reduction in the
maximum active power that can be fed in.
F
Enter the minimum cos ϕ factor for quadrants 1 and 4.
4
1
2
3
4
Priority mode
Q priority | P priority
F
Set priority for reactive power – Q or active power – P.
NOTE: When it comes to P priority, the reactive power adjust-
ment range is limited subject to the active power that is cur-
rently available and fed in.
4
1
2
3
4
Active curve
1 - 4
F
Select active curve.
NOTE: Up to 4 characteristic curves can be configured inde-
pendently and one of them can be activated for regulation
each time.
4
1
2
3
4
Reset the curve
F
Reset active curve to the default setting.
4
1
2
3
4
Number of nodes
2 - 10
NOTE: The maximum number of configurable nodes depends
on the selected grid type.
F
Specify the number of nodes for the Q(U) characteristic curve.
4
1
2
3
4
Exten. standalone grid
NOTE: Grid operators require shutdown of the device with
standalone grid detection.
F
Further parameterisation is possible via the web interface.
BE CH-NS
CY DE-NS
DK JP-50HZ
JP-60HZ
LU-NS TW
UD
4
1
2
3
4
Grid errors
NOTE: Display of grid faults.
F
To show the last 5 grid fault messages, press the
Show button.
4
1
2
3
4
Advanced features
F
Further parameterisation is possible via the web interface
4
1
2
3
Information
Open the menu: Press Right arrow button or Enter button.
4
1
2
3
4
Inverter type
Displays the type designation of the device. If feed-in power is actively
limited: display maximum power in kW.
4
1
2
3
4
Display country
Displays the selected country setting. Optional: Displays the grid type if
a grid type has been selected.
4
1
2
3
4
Vendor
The display shows information about the device manufacturer.
9.4.2
Configuration via web user interface
NOTE
In addition to the parameters in the chapter [See section 9.4.1
Page 35], additional parameters are available
and accessible via the web user interface. To do so, enable
Remote config
in
Network
under
Web-
server
and enter the device IP address into your browser.
4
1
2
3
4
Operating settings
NOTE: Options for advanced setting of the operating paramet-
ers.
4
1
2
3
4
DC starting volt.
The device begins feed-in as soon as this DC voltage is present.
F
Set the starting voltage.
Manual
Configuration and operation | 9
KACO blueplanet 3.0 TL3 KACO blueplanet 4.0 TL3 KACO blueplanet 5.0 TL3 KACO blueplanet 6.5 TL3 KACO
blueplanet 7.5 TL3 KACO blueplanet 8.6 TL3 KACO blueplanet 9.0 TL3 KACO blueplanet 10.0 TL3
Page 45
EN
