7
H. CHECKING THE LOCK’S OPERATION
IMPORTANT:
The following steps MUST be performed while the DOOR IS OPEN.
Note:
Turning the outside thumbturn to the left (counterclockwise) to the stop
position and releasing extends the bolt to the locked position. To retract the
bolt from the outside, depress the buttons of your preset combination, then
turn the thumbturn to the right (clockwise) to the stop position.
H-1
Turn the outside thumbturn to the left (coun-
terclockwise) until it stops, then release it
(See
Figure 8-1).
H-2
Press the preset factory combination (2 and 4
pressed together, release, then 3, and release)
(See Figure 8-2).
A distinctive click must be
felt to indicate that the buttons have been cor-
rectly depressed.
H-3
Turn the
outside
thumbturn to the right (clock-
wise) until it stops; the bolt should fully retract
(See Figure 8-3)
. If the bolt does not retract,
turn the thumbturn to the left (counterclock-
wise) until it stops. This will clear previously
depressed buttons. Release it and repeat Steps
H-2 and H-3.
H-4
Release the
outside
thumbturn; the bolt will
stay in the retracted position.
H-5
Turn the
inside
thumbturn
A
to the stop posi-
tion; the bolt will extend to its locked position
(See Figure 8-4).
H-6
If the bolt does not retract or extend fully,
loosen the two thru-bolts of the inside thumb-
turn assembly
A (See Figure 8-4).
Move the
inside thumbturn assembly upward or down-
ward to properly center the inside thumbturn
assembly with the tailpiece, then tighten the
thru-bolts, and repeat Steps H-1 to H-5.
H-7
If the bolt still does not fully retract or extend
after repeating Step H-6, loosen the two thru-
bolts of the inside thumbturn assembly
A
and combination change
assembly
B (See Figure 8-4)
. Move the lock upward or downward to
properly align both tailpieces of the inside thumbturn assembly and
combination change assembly. Tighten the four thru-bolts and repeat
Steps H-1 to H-5 to ensure proper operation.
8-1
8-2
8-3
8-4
B
A
Summary of Contents for 7102 series
Page 1: ...7 1 0 2 7 1 0 8 SERIES Installation Instructions ...
Page 17: ...Notes ...
Page 23: ...13 Notes ...
