Kaba 7102 series, Installation Instructions Manual

Page: 7 / 24

5
E-2 Left Hand Door (see template)
a. Insert the bolt, with the arrow pointing down ,
into the 1" (25 mm) hole (See Figure 5-2).
b. Secure the bolt face plate to the door with
the two Phillips-head screws provided.
F. ADJUSTING THE LOCK
The lock has been pre-assembled to
accommodate doors up to 2 1 ⁄
4
" (57 mm) thick.
If your door is 1
3
⁄
8
" to 2 " (35 mm to 51 mm) thick,
you must shorten both tailpieces X and Y (See
Figure 6-1) .
F-1. Shorten the combination change tailpiece X
according to your door thickness. Tailpiece X
has been premarked for various door thick-
nesses for accuracy and convenience (See
Figure 6-1) .
a. After determining the breakoff point, hold
the tailpiece firmly with a pair of pliers on
the lock side of the tailpiece, just beside
the desired break line (See Figure 6-2) .
b. With a second pair of pliers, grip the
tailpiece at the other side of the line
and bend it up and down until it breaks
(See Figure 6-2).
F-2. While holding the lockset firmly against the outside surface of the door,
(See Figure 6-1) , mark tailpiece Y at the point where it extends
1 ⁄
2
" - 5 ⁄
8
" beyond the interior surface of the door.
a. After determining the breakoff point, hold the tailpiece firmly with a pair
of pliers on the lock side of the tailpiece, just beside the desired break
line (See Figure 6-2) .
b. With a second pair of pliers, grip the tailpiece at the other side of the
line and bend it up and down until it breaks (See Figure 6-2).
5-2
6-2
1
X
Y
2
6-1