6
Unlock the Lock - Master/Manager Pre-Set
1.
Press and hold the
key until the yellow light
Y
displays.
2.
Enter any valid three-digit User ID for the lock model followed by the default
factory PIN for the User ID. ( For
User ID 111
the default PIN is “
12345
”. For all
other Users IDs the default PIN is “
55255
”. )
If the combination is entered successfully, the lock displays one green flash
G
with a beep
to indicate that a valid combination has been entered.
One long green flash
G
displays with a beep
to indicate that the motor has
fired and the lock is unlocked.
Note:
A “lock open” audit record is written at this point.
3.
Turn the lock knob clockwise (CW) to the “unlocked” position to open the
secured unit (cabinet, cart, drawer, etc.)
Practice locking and unlocking the lock several times with the pre-set PINs before
you set a new combination.
To Lock/Unlock Using the Lock User Pre-Set Combination
Your lock has been shipped so that
the factory pre-set access combination for the
Lock User will lock or unlock the lock.
Lock the Lock - Lock User Pre-Set
1.
If necessary, turn the lock knob counter clockwise (CCW) to the “locked”
position.
2.
Enter the default factory access combination of
5525
for the Lock User.
3.
Press and hold
until yellow light
Y
displays.
If the combination is entered successfully, the lock displays one green flash
G
with a beep
to indicate that a valid combination has been entered. One long
green flash
G
displays with a beep
to indicate that the motor has fired and
the lock is in the “locked” state. A long red flash
R
is displayed with a beep
to indicate that the knob is in the closed position and the lock is locked.
Note:
A “lock close” audit record is written at this point if the knob is in the “locked”
position. If the knob is not fully turned CCW to the “locked” position, the long red
light
R
will not display at the end of the operation and the “lock close” record will
not be written.
