4
Lock Responses
•
If sound is toggled “off”, no beeps
will sound.
•
After each keystroke a green flash
G
is displayed with a beep
. If the lock
does not respond, the key was not pressed properly.
•
After each accepted step of an operation, simultaneous green and red flashes
G
R
display with a beep
, prompting you to enter additional information for the next step of
the operation.
•
After you have completed all the steps of an operation, two simultaneous green and red
flashes display with beeps
G
R
G
R
if the operation is successful. Three
red flashes
R
R
R
display with beeps
if the operation is unsuccessful, and you
will need to re-key the operation that caused the error.
•
If a valid combination is entered to lock or unlock the lock, response will be as follows:
·
If a valid combination is entered
to lock or unlock the lock, the lock will respond
with one green flash
G
and a beep
to indicate that a valid combination has
been entered. If unlocking the lock, one long green flash
G
displays with a beep
to indicate that the motor has fired and the lock is unlocked. If locking the lock, a
long red flash
R
is displayed when the knob is returned to the closed position.
·
If a valid combination is entered to open the lock but the motor does not fire
(motor fire error),
the lock will respond with one green flash
G
and a beep
to
indicate that a valid combination has been entered but will then display three red
flashes
R
R
R
with simultaneous beeps
to indicate an error firing the motor.
•
A low battery condition
is indicated by ten fast yellow flashes after a valid combination
has been entered. Normal operation and responses occur after that, as described above.
For instructions on how to change batteries, see the following section on
Lock Mainte-
nance.
•
A keystroke error or invalid combination
is indicated by three red flashes
R
R
R
with simultaneous beeps
.
•
After three consecutive failed entry attempts
(invalid combinations), the lock will be
disabled for three minutes. Slow red flashes
R
display with beeps
approx. every 2
seconds during this period. Any additional failed entry attempts (after the first three
consecutive attempts) result in the lock disabling for three minutes after each failed entry
attempt.
•
When new batteries are installed properly
, the lock will indicate this “powered”
condition with simultaneous red, green, and yellow flashes with a beep
followed by
two simultaneous red and green flashes with beeps
.
•
If new batteries are not installed properly or if batteries are almost dead
, the lock
may indicate this condition with six quick red flashes
R
R
R
R
R
R
with
simultaneous beeps
. The batteries must be reinserted properly or replaced.
