13
S
OFTWARE
B
ASED
L
OCK
O
PERATIONS
Upload Data to Lock
As an alternative to defining setup data and user data manually at the lock, certain
types of data can be defined at the PC using the Unicon CL Series Software and the
information can then be uploaded (transferred) to the lock via a Smart Key.
Caution:
If you are using the software to program the lock, you should not also be
programming the lock manually at the lock (except perhaps in case of emergency
where someone needs to be immediately deleted from a lock.) If you do update the
lock manually, you must then update the same information at the PC. Data
synchronization issues will occur if the data at the PC and the data at the lock are
not kept the same.
Program Lock
If you choose the “Program the Lock” menu option from the Unicon CL Series PC
software, you can define the following data in a Unicon CL10 lock:
•
Lock ID
•
Sound ON/OFF
•
Reporting Capabilities
•
Users
•
Date & Time
Note:
The Program Lock operation requires a teal colored (blue green) programming key
fob that has been properly prepared at the PC using the Unicon CL Series Soft-
ware.
To program the lock, complete the following steps:
1.
Press
#
Y
and then
2
.
G
R
2.
Enter the Master User combination. Short red flashes with beeps
R
begin
to display. From the time these flashes begin, you have 20 seconds to properly
insert the prepared teal programming key fob into the lock key fob reader. If you
do not properly insert the key fob within the 20 second period, short red flashes
followed by three red flashes display with beeps
R
R
R
to indicate
an error and you will need to re-key the operation. If the programming key fob
has not been properly initialized, three red flashes display with beeps
R
R
R
.
3.
Ensure that the key fob remains connected to the key reader until the lock
has completed uploading the programming data. Upon completion, two
simultaneous green and red flashes display with beeps
G
R
G
R
indicating that the programming of the lock is complete.
