23
INSTALLATION (Phase Two)
Dorma F9300 Fire Rated Exit Device
depending ON THE HE
DOOR THICKNESS
A. Choose the required spindle depending on the door thickness.
B. Remove the template. Mark the door to denote the lock and strike horizontal line.
C. Insert the slotted end of the spindle
(D)
into the outside housing until it locks, at the correct position for the
exit device. The spindle can be removed by pulling on it, and re-inserted if oriented incorrectly.
D. Place the outside housing
(B)
on the door. (
for exterior use use the gasket (C) if required
)
E. Attach adaptor plate
(E)
to the lock
(B)
using flat head screws
(F)
(
12-24nc
).
F. Attach the exit device chassis
(G)
to the adaptor plate
(E)
4 screws
(H).
G. Make sure the lock and the exit device chassis are well aligned and then tighten screws.
Fig. 4 Spindle Position
Dorma F9300
Figure 1
Figure 2
23
Summary of Contents for DKX-10
Page 37: ...NOTES ...
Page 38: ...NOTES ...
