18
F.
Remove the key. (
The lock will look as shown at right.
)
G.
Gently check the rotation of the lever handle.
(
It should easily rotate approximately 45º.)
H.
Use the
5
/
32
" hex key and tighten the set screw
while pushing the lever against the plastic
washer to remove the lever play.
Test the Operation of the Outside Lever
Verify that the lever has been correctly attached to the housing:
A.
Remove key.
B.
Insert a small flat screwdriver into the hole on the underside of the lever
handle and push in the lever catch.
C.
Pull on the lever.
(
You should not be able to remove the lever. If the lever comes off of the housing, the
lock is not assembled correctly. Re-do steps A-C in Phase One/Section
E- Install the
Outside
Lever
of dormakaba PowerPlex P2000.
)
Troubleshooting:
If you have assembled the lever and housing
with the key in the wrong position, the key will get stuck. To
remove the key, turn it so that it is in the vertical position and
insert a small flat screwdriver into the hole under the lever handle
to push the lever catch in
(f)
. Remove key. If it is still stuck, turn the
key clockwise until it stops to the horizontal position and push the
lever catch in again with the small screwdriver. Remove key.
Right-Handed lock
Left-handed lock
Troubleshooting:
Right-handed Lock: Turn the lever handle clockwise without forcing it. If it stops at
approximately 15º, it was not assembled correctly. Do not try to force it to turn
—
this
will damage the inside mechanism of the lock. Release the lever handle. Insert the
small screwdriver into the small hole on the underside of the lever handle and push in
the lever catch.
Re-do steps A-C in Phase One/Section E- Install the Outside Lever of dormakaba
PowerPlex P2000.
Left-handed Lock: Turn the lever handle counterclockwise without forcing. The drive
hub should not rotate when the lever handle is turned. If it does, it was not assembled
correctly. Release the lever handle. Insert the small screwdriver into the small hole on
the underside of the lever handle and push in the lever catch.
Re-do steps A-C in Phase One/Section E- Install the Outside Lever of dormakaba
PowerPlex P2000.
Figure 14
Figure 15
18
Summary of Contents for DKX-10
Page 37: ...NOTES ...
Page 38: ...NOTES ...
