13
INSTALLATION (Phase One)
dormakaba PowerPlex P2000
A.
Use the template and mark the desired handle height on the edge of the door.
(
See Figure 7.)
Note:
Recommended centerline is 40
5
/
16
".
B.
Use the template and mark a 2
3
/
8
" backset vertical line (
or the appropriate
backset for your installation
). Mark a horizontal line 40
5
/
16
" above the floor.
C.
Position the template on the inside of the door aligning the door handle
height mark and backset vertical line mark with the lines on the template. Use
masking tape to secure the template to the door. Mark the position of the
holes on the door. Remove template.
D.
Using a
3
/
16
" drill bit, drill the pilot holes to the appropriate depth as indicated
on the template.
E.
Enlarge the pilot holes to the size that is indicated on the template.
Note:
It is
recommended that you drill from both sides of the door to eliminate the
possibility of splintering.
Note:
Drill the holes in the door required for the exit device as indicated on the template.
(4) Holes
1/2”
Backset Vertical Line
From the inside, counter bore
(4)
3
/
8
" dia. ×
1
/
2
"
deep holes.
See Drilling Template
Figure 8
Figure 7
1"
Through
Hole
(3)
3
/
8
" Through Holes
From the inside, counter bore
(4)
3
/
8
" dia. ×
1
/
2
"
deep holes.
See Drilling Template
13
Summary of Contents for DKX-10
Page 37: ...NOTES ...
Page 38: ...NOTES ...
