4
Mount the fall prevention wire to the
camera (for connecting the ceiling
mount section to the camera).
0
Mount the fall prevention wire, which is
attached to the camera, to the fall prevention
wire fixing bracket of the ceiling mount
section.
Caution
0
The camera may fall if the fall prevention
wire is not connected. Be sure to connect
the fall prevention wire.
0
For safety purposes, do not leave the fall
prevention wire dangling by the camera.
5
Mount the camera and check the
camera lock knob.
0
Align the “
D
mark (blue)/(red)” inside the
camera with the “
D
mark (blue)/(red)” on the
ceiling mount section.
0
Mount the camera securely by inserting it
into the ceiling mount section until you hear
a click sound.
0
If the camera is mounted on securely, the
camera fixing lock knobs (x2) will stick out a
little.
.
4
5
After
mounting
During
mounting
Check the knob.
Fall-prevention
Wire on Camera
D
mark (red)
D
mark
(blue)
Fall prevention wire
fixing bracket
Note :
0
Before mounting the camera, check that the
camera fixing lock knobs are not locked (i.e.,
lock knobs are on top). The camera cannot be
mounted if the lock knobs are locked.
0
When pulling out the cables from the side,
remove the cable cover of the camera.
P24 [Pulling out the cables from the side] )
6
Lock the camera fixing lock knobs (x2)
0
When the camera is mounted on the ceiling
mount section, lower the camera fixing lock
knobs (x2) in the direction of the arrow and
secure the camera such that it does not fall
off.
.
Camera fixing
lock knob (x2)
Caution
0
The camera may fall if the camera fixing lock
knobs (x2) are not locked. Be sure to check
that the lock knobs are firmly locked.
0
Improper mounting may cause the camera
to fall off. After mounting, check that the
camera is mounted securely.
Installation of the camera is complete. Next, set
the IP address of the camera.
P32 [IP Address Setting Procedure] )
Removing the Camera
1
Release the lock by sliding the camera
fixing lock knobs toward the ceiling.
2
Press the two camera fixing lock
knobs from both the left and right
sides to remove the camera unit.
3
Remove the fall prevention wire by
performing the mounting procedures
in the reverse sequence.
26
Mounting the Camera (VN-H657U)
Moun
tin
g
the
Ca
m
era
