42
Adjusting input signal
(See page 19)
When using the DSP mode effect during playback from an analog
device, the sound will occasionally be distorted due to a overly-
strong input signal. In these instances, it is possible to adjust the
level of the input signal. Only input signals from analog devices (TV
SOUND, VCR, TAPE, AUX, MD, DBS) may be adjusted in this
way.
1.
Open the SOUND MENU.
See page 41, “Opening the SOUND MENU”.
2.
Move the pointer to INPUT ATT. using the
5
/
∞
cursors.
3.
Use the
2
/
3
cursors to select ON or NORMAL.
Pressing
2
/
3
toggles loudness ON or NORMAL.
ON
:
Recommended to reduce sound distortion.
NORMAL :
Default setting.
Notes:
• This setting does not affect digital signals.
• When in ON mode, ATT will light up in the display window.
However, when the playback source is digital (DVD, etc.) it will
go off. Lighting up will resume if playback is switched to an
analog device.
• Even while in ON mode, if the DSP mode is turned off (“DSP
OFF”), playback will continue without any reduction of the input
signal.
Adjusting the sub-woofer output level
When the sub-woofer output level is too high, use the LFE
Attenuator to lower the output level.
1.
Open the SOUND MENU.
See page 41, “Opening the SOUND MENU”.
2.
Move the pointer to LFE ATT. using the
5
/
∞
cursors.
3.
Use the
2
/
3
cursors to select ON or OFF.
Pressing
2
/
3
toggles loudness ON/OFF.
ON
:
Recommended to reduce sound distortion.
NORMAL :
Default setting.
Adjusting the dynamic range
It is possible to compress the dynamic range (the difference between
the loudest and quietest audio signals).
This is useful when enjoying surround sound at nighttime.
This function is only available when the source is recorded in Dolby
Digital.
1.
Open the SOUND MENU.
See page 41, “Opening the SOUND MENU”.
2.
Move the pointer to COMPRESSION using the
5
/
∞
cursors.
3.
Use the
2
/
3
cursors to switch between MID,
LARGE, and OFF.
MID
:
Slightly compresses the dynamic range.
LARGE :
Maximum compression of the dynamic range.
(recommended for nighttime listening).
OFF
:
Choose this option to enjoy surround sound with the
regular dynamic range.
Adjusting the DSP effect
Adjusting DSP (Digital Signal Processor) effects.
You can make adjustments for each DAP mode and save them in
memory.
1.
Open the SOUND MENU.
See page 41, “Opening the SOUND MENU”.
2.
Move the pointer to DSP EFFECT using the
5
/
∞
cursors.
3.
Use the
2
/
3
cursors to adjust the DSP effect.
Choose a DSP effect level between 1 ~ 5.
• The pointer cannot be adjusted to the DSP effect when “- -”
appears.
SOUND MENU Settings
TH-A10[J]5/1
00.2.24, 14:55
42
Downloaded From TheatreSystem-Manual.com Manuals
