– 7 –
R
CAUTION:
L
R
L
SPEAKER IMPEDANCE 4~16
Ω
SPEAKERS
1
If cords are covered with insulation, twist the core of
the cord at the end of each cord, then remove the
insulation.
2
Connect the AM (MW/LW) loop antenna to the AM
LOOP terminals as illustrated.
3
Turn the AM (MW/LW) loop antenna until you have
the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
The AM (MW/LW) loop antenna must remain connected.
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
AM (MW/LW) antenna
Connecting Speakers
To connect speakers
You can connect the speakers using the speaker cords.
3
Vinyl-covered wire
(not supplied)
AM (MW/LW) loop antenna
(supplied)
2
1
1
If cords are covered with insulation, twist the core of
the cord at the end of each cord, then remove the
insulation.
2
Hold the clamp of the speaker terminal.
3
Insert the end of the speaker cord to the terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
4
Release the finger from the clamp.
IMPORTANT
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• DO NOT connect more than one speaker to one speaker
terminal.
Speaker cord
Rear of the left
speaker
1
3,4
2
Rear of the right
speaker
Black
Red
Speaker terminals
Red
Black
Black
EN01-09UX-Z7MDR[B]f
02.6.28, 13:46
7
