![JVC KM-H2500 Manual Download Page 39](http://html.mh-extra.com/html/jvc/km-h2500/km-h2500_manual_179509039.webp)
33
Note:
• You can also select an effect by pressing the
Pattern buttons as shown in Table 7 :
• Using the
Effect
knob allows you to select one
extra DVE effect. The 1000 pound effect is not
available from the Pattern buttons.
Using the Memory System
The built-in memory system can store up to 100
switcher memories (10 banks of 10 memory
locations). This allows you to save the settings for a
later time without having to make the adjustments
again.
Choosing a Memory Access Mode
There are two ways to access the memory system:
•
Direct Access Mode
— You can access any of
the 100 memories by pressing two buttons (one for
the bank and one for the memory location).
•
Bank Mode
— You pre-select a bank and then
access any of the 10 memories in that bank with a
single button press.
To select the memory access mode:
1.
Press
STORE
.
2.
Press
NEXT
.
3.
Use the right knob to select the memory access
mode. You can choose from the following:
•
DirAcc
— Use Direct Access Mode.
•
Bank
— Use Bank Mode.
Storing Memory Registers
Storing settings to a memory register allows you to
save an effect for re-use.
To store a setting to a memory register:
1.
Press the
STORE
button.
2.
Select the storage area you wish to save to as
follows:
• If you are using Bank Mode, press a Wipe
Pattern button to designate the memory
register in the selected bank. You may also
use the
Bank
knob to change the selected
bank before storing.
• If you are using Direct Access Mode, press a
Wipe Pattern button to designate the desired
bank and then select a second Wipe Pattern
button to designate the memory register.
Note:
• You can exit without storing a memory register by
pressing any button other than a Wipe Pattern,
dedicated key transition,
CUT
,
AUTO TRANS
, or
source button.
• The switcher is set to recall memory registers
immediately after storing a memory register.
Recalling Memory Registers
Recalling the memory register allows you to quickly
re-use the effect you previously stored.
Table 7 DVE Effect Selection
Pattern
Button
Single Press Pattern
Button DVE Effect
Double Press Pattern
Button DVE Effect
0
Push Left
Push Right
1
Push Up
Push Down
2
Squeeze Horizontal
Push Up-Right
3
Squeeze Vertical
Push Down-Left
4
Push Up-Left
Push Down-Right
5
Squeeze Up-Right
Squeeze Down-Left
6
Squeeze Up-Left
Squeeze Down-Right
7
Squeeze to Center
Fly Through
8
Circle Left
Circle Right
9
Stretch
Tumble
3
2
1
2
1