21
ENGLISH
Activating crossover network
By activating crossover network, you can
allocate different frequency range of sound
signals to different speakers to match their
characteristic.
If you have installed the 3-way network
speaker system in the car, make sure of the
following:
• Before using the system, activate crossover
network and preset the appropriate cutoff
frequencies for HPF/LPF (especially
for HPF); otherwise, it may damage the
speakers.
• For 3-way network speaker system, see
Installation/Connection Manual (separate
volume).
You cannot perform other operations until you
finish the following procedure.
While the power is turned off...
~
Ÿ
!
•
To cancel the procedure,
press and
hold POWER/ATT/ENTER. The power
turns off.
⁄
Finish the procedure.
•
indicator
lights up (in sequence
with other indicators).
To cancel Crossover,
repeat the same
procedure. Make sure that “X-Over Off OK?”
appears on the display.
•
indicator goes off.
Setting the sound modes—SEL
You can adjust the sound characteristics to your
preference.
~
Enter the SEL menu (see page 4).
Ÿ
Select a setting item.
*
Appears only when crossover network is
activated (see left column).
When selecting “Fad/Bal,” “X-Over,” or
“S.woofer,” press POWER/ATT/ENTER
to enter its submenu.
!
Adjust the selected setting item.
(See the following for details.)
• To adjust other SEL settings, press
BACK. Then repeat steps
Ÿ
and
!
.
⁄
Finish the procedure.
To adjust fader and balance—Fad/Bal
•
Fad (fader)
Adjust the front and rear speaker balance.
•
Bal (balance)
Adjust the left and right speaker balance.
EN18-23_SH1000E_003A_f.indd 21
EN18-23_SH1000E_003A_f.indd 21
1/16/06 3:57:00 PM
1/16/06 3:57:00 PM