(No.YF124)1-13
3.2.4 ASSEMBLY/DISASSEMBLY OF [13] OP BLOCK ASSMBLY/CCD BOARD ASSEMBLY
z
Precautions
(1) Take care in handling the CCD IMAGE SENSOR, OPTI-
CAL LPF and lens components when performing main-
tenance etc., especially with regard to surface
contamination, attached dust or scratching. If finger-
prints are present on the surface they should be wiped
away using either a silicon paper, clean chamois or the
cleaning cloth.
(2) The CCD IMAGE SENSOR may have been shipped with
a protective sheet attached to the transmitting glass.
When replacing the CCD IMAGE SENSOR, do not peel
off this sheet from the new part until immediately before
it is mounted in the OP BLOCK ASSEMBLY.
z
Disassembly of OP BLOCK ASSEMBLY / CCD BOARD AS-
SEMBLY
(1) Unsolder the fourteen soldered points (SD13a) of the
CCD BOARD ASSEMBLY.
NOTE13a:
Be careful in handling as there are only the OPTICAL
LPF and the SHEET stored inside the OP BLOCK
ASSY when the CCD BASE ASSY is removed.
NOTE13b:
Replace the CCD IMAGE SENSOR as a CCD BASE
ASSEMBLY, not as a single part replacement.
(2) Remove the two screws (1, 2), and then remove the CCD
BOARD ASSEMBLY and the CCD BASE ASSEMBLY.
z
Assembly of OP BLOCK ASSEMBLY / CCD BOARD AS-
SEMBLY
(1) Set the OPTICAL LPF first, and then the SHEET to the
OP BLOCK ASSEMBLY.
NOTE13c:
Pay careful attention to the orientation of the OPTICAL
LPF.
(2) Attach the CCD BASE ASSEMBLY first then the CCD
BASE ASSEMBLY so that the SHEET stays in place,
and tighten with the two screws (1, 2).
(3) Solder the 14 points (SD13a) on the CCD BOARD AS-
SY.
z
Replacement of service repair parts
The service repair parts for the OP BLOCK ASSEMBLY are as
listed below.
Before replacement of these parts, remove the BRACKET (OP
BLOCK ASSEMBLY) as required.
Take special care not to disconnect any of the FPC wires or
cause any damage due to soldering (excessive heating).
(1) FOCUS MOTOR UNIT
(2) ZOOM MOTOR UNIT
(3) AUTO IRIS UNIT
NOTE 13d:
When replacing the FOCUS MOTOR UNIT or the ZOOM
MOTOR UNIT, solder the FPC at a space of about 0.5 mm
above the terminal pin.
NOTE 13e:
The AUTO IRIS UNIT includes the FPC ASSEMBLY and
two sensors.
Fig.3-2-4
SD13b
0.147N
m (1.5kgf
cm)
NOTE13c
NOTE13a,b
NOTE13d,e
CCD BOARD ASSEMBLY
CCD BASE ASSEMBLY
AUTO IRIS UNIT
SENSOR
SHEET
OPTICAL LPF
CUSHION(OP)
2
(S13a)
SD13
1
(S13a)
3
(S13b)
4
(S13b)
ZOOM MOTOR UNIT
NOTE13d,e
5
(S13b)
7
(S13b)
8
(S13b)
9
(S13b)
6
(S13b)
NOTE13b
FOCUS
MOTOR UNIT
