repeater to the router again.
③
Reset the repeater.
Q13: Why does the wireless network show strong signal strength but low speed after
extension?
A13: Check the signal strength indicator on the physical housing of the repeater.
①
One LED on: weak receiving signal, strength below 25%.
(In this case, it is recommended to put the repeater closer to the router, and keep
their antennas in parallel.)
②
Two LEDs on: Good receiving signal, strength between 50~75%.
③
Three LEDs on: Excellent receiving signal.
•
In general, the repeater works in its best performance when the strength of signal
that the repeater receives is between 50% and 75% (when the Web page shows the
signal of 3 bars).
•
Check the network speed when your mobile device connects to the router directly
at that position.
If the wireless network speed of the router is similar to that of the repeater, the
connection is normal.
When the wireless network speed of the router is faster than that of the repeater,
please check the following:
①
Check the location of the repeater. Do not put it at a corner.
②
Check if the antennas of the repeater and router are in parallel. Antennas aligned
in parallel ensures better connection.
③
If it still does not work, reset the repeater, and try connecting the repeater to the
router again.
④
Reset the repeater.
Q14: Why does single frequency extended state after successful extension?
A14: The signal may be hidden. Please check if the encryption mode is WPA, WPA2,
or mixed of the above;
if the encryption key contains special characters; if the signal channel is changed.
Then, try extending
the wireless network again.
Q15: Why can't I extend Comcast,Verizon router signal?
A15: The encryption method used by the Comcast,Verizon router may not be
recognized by EC4-1200 Wi-Fi Extender. Try the following solutions to solve the
problem:
①
Log in to Comcast, Verizon router and enter the wireless setting page
。
②
Change the wireless encryption method to WPA/WPA2.or WPA-PSK/WPA2-PSK.
③
Confirm the setting and use EC4-1200 Wi-Fi Extender to search the router signal
FCC Statement
