Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Manual

Page: 53 / 104

Figure 6: Shared Disk Options for Regional Servers
Figure 7: Shared Disk Options for Central Managers
NSMXpress Series II supports shared disk via NFS only. Due to the data-intensive
nature of NSM, we recommend gigabit speed links (1000 Mbps) for shared disk use.
For more information about custom settings, refer to the
Network and Security Manager
Installation Guide .
9.
(Optional) Click Menu next to HA Links (see Figure 5 on page 32) to configure the
second link in the HA cluster (see Figure 8 on page 33).
Figure 8: HA Links Options
Use the options in this menu to set up a redundant link for the HA cluster. If you are
going to use a second link, you need to set the IP address for eth1 before configuring
this setting (see “Configuring the Network” on page 43 for details). Setting a redundant
link is optional. For more information about custom settings, refer to the
Network and
Security Manager Installation Guide .
If you configure HA with just one heartbeat link, then device management traffic and
data replication traffic both use that link. If you configure two links, device management
traffic uses the first link and data replication uses the second.
33 Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Configuring NSM from the Web Interface