Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Manual

Page: 32 / 104

4> NSM License type []
Specify a license file, or select "Base Install"
to use the built-in limited device license.
A> Apply settings
C> Cancel all changes and quit
R> Redraw menu
Choice [1-4,A,C,R]:
To select an option, enter the number at the prompt and then press Enter. The following
options are available on most menus:
•
Numbered Options—Enter setting options by number ( 1 , 2 , and so on) to access
individual parameters or open menus.
• Apply settings—Enter A to apply and save any modifications you have made and take
you out of the setup program.
•
Cancel all changes and quit—Enter C to leave the setup program without saving any
changes you made since you last saved.
• Redraw menu—Enter R to redraw the screen text.
•
Main Menu/Return to Main Menu—Enter M to return to the main menu. This option is
last on most menus.
• Quit—Enter Q to exit from the setup program. You will be prompted to save or cancel
any changes you made since you last saved:
Q> Quit
R> Redraw menu
Choice [1–9,Q,R]: Q
Using nsm_setup
After initial setup, you can cancel out of the setup program and later return to it. Follow
these steps to return to the NSMXpress Series II setup program. The steps in this procedure
assume thatNSMXpress Series II is connected to a computer running a terminal emulation
program. If not, see “Initial Setup Configuration” on page 8 for details.
NOTE: Run nsm_setup with your “admin” user login only. Do not run
nsm_setup as an “nsm” user.
To return to the setup program after the initial setup:
1.
Turn on the NSM appliance and wait for the login prompt:
Juniper NSMXpress NSM 2010.4r1 Kernel 2.6.9–42.0.8.ELsmp on an i686
NSMXpress.juniper.net logon: admin
Password:
Las Login: Tue May 17 09:43:50 on tty50
Run NSMXpress system setup? [y/N] N
Copyright © 2010, Juniper Networks, Inc. 12
NSMXpress Series II User Guide