Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Manual

Page: 31 / 104

CHAPTER 2
Installing and Configuring NSM from the
CLI
This chapter describes how to install and configure NSM on your NSMXpress Series II
appliance from the command-line interface (CLI). It contains the following sections:
• Navigating the Menus on page 11
• Configuring the NSM Software on page 13
•
Configuring a Regional Server on page 14
•
Configuring the Central Manager on page 19
• Configuring Standard Configuration Options on page 23
• NSMXpress Series II Default Restoration on page 27
Navigating the Menus
As you configure NSM on your NSMXpress Series II appliance, the following standard
navigational menu options are available to you. This section provides information on
general options you can use during setup and configuration. These options include:
•
General Options on page 11
•
Using nsm_setup on page 12
General Options
The NSM Configuration Main Menu has the following options:
NSM Configuration Main Menu
1> Management IP [10.150.43.205]
The IP address on this server that will be
used for management
2> NSM 'super' password []
Password for 'super' user
3> GUI server one-time password []
Password to initiate authentication
between HA peers and to Central Manager.
This password must be the same for all
NSM servers in this installation.
11 Copyright © 2010, Juniper Networks, Inc.