Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Manual

Page: 44 / 104

3.
Type the new password and press Enter.
4.
Retype the new password and press Enter.
Your password is changed and the setup program returns you to the NSMXpress Series
II Settings menu.
Setting Interface Options
NSMXpress Series II has two ports labeled ETH0 and ETH1. During initial setup, you specify
the eth0 interface options. Use this menu to set interface options for eth1 or modify either
interface.
NOTE: If you are going to use a second link, you need to configure an IP
address for eth1 before configuring this setting.
To set or modify interface options:
1.
On the NSMXpress Series II Settings menu, enter 2 at the prompt. The menu shows
the existing status of each interface.
2.
Set or modify options for one of the interfaces by selecting one of the following options:
• 1 to modify eth0.
•
2 to set or modify eth1.
3.
Make the following selection for interface options by selecting one of the following
options:
•
1 to change the IP address and return to the NSMXpress Series II Settings menu.
• 2 to go to the next step.
4.
Make the following selection for physical parameters (such as interface speed) by
selecting one of the following options:
• 1 to set the autonegotiate option and return to the main menu.
•
2 to set the physical parameters manually and go to the next step.
5.
Select the interface speed by entering one of the following options:
•
1 for 10 Mbps and go to the next step.
•
2 for 100 Mbps and go to the next step.
•
3 for 1000 Mbps and go to the next step.
6.
Enter 1 for full duplex or 2 for half duplex, and then return to the NSMXpress Series II
Settings menu.
Setting Routing Options
To set or modify routing options:
Copyright © 2010, Juniper Networks, Inc. 24
NSMXpress Series II User Guide