Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01, Manual

Page: 48 / 104

1.
Turn on NSMXpress Series II.
2.
Press any key while the Booting NSMXpress countdown scrolls through the screen to
access the boot menu:
Press any key to enter the menu
Booting NSMXPress
Booting NSMXpress
Booting NSMXpress
Booting NSMXpress
Booting NSMXpress
Booting NSMXpress
in 4 seconds...
3.
Use the arrow keys to select Re-Install current-version-number , and then press Enter:
NSMXpress
Rescue
Re-Install <current—version—number>
Re-Install <previous-version-number>
Rescue Boot from Secondary Drive
NOTE: If you have not updated the recovery partition through the Web
UI, only the Re-install option (option to install the previous version) is
displayed.
4.
Read the paragraph, and then press Enter .
Booting 'Re-Install'
Using this option will completely erase your appliance and load the factory
default image. No data recovery is possible after re-installing. To confirm
erase and re-install, type “erase” as the password prompt. To abort and
boot
into Rescue mode, just hit <Enter> at the password prompt. Press any key.
5.
Enter erase at the prompt to erase the disk. This task will take a few minutes.
When reinstallation is finished, you are prompted to login.
Copyright © 2010, Juniper Networks, Inc. 28
NSMXpress Series II User Guide