Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X, Configuration Manual

Page: 55 / 366

■
Use the out keyword to assign the prefix list to outgoing routes (outbound policy);
you cannot configure a member of a peer group to override the inherited peer
group characteristic for outbound policy
■
Example
host1(config-router)# neighbor 192.168.1.158 prefix-list seoul19 in
■
Use the no version to remove the prefix list.
■
See neighbor prefix-list.
neighbor prefix-tree
■
Use to assign an inbound or outbound prefix tree.
■
If you specify a BGP peer group by using the peer-group-name argument, all the
members of the peer group inherit the characteristic configured with this
command unless it is overridden for a specific peer.
■
Use the in keyword to assign the prefix tree to incoming routes (inbound policy)
■
Use the out keyword to assign the prefix tree to outgoing routes (outbound
policy); you cannot configure a member of a peer group to override the inherited
peer group characteristic for outbound policy
■
Example
host1(config-router)# neighbor 192.168.1.158 prefix-tree newyork out
■
Use the no version to remove the prefix tree.
■
See neighbor prefix-tree.
redistribute
■
Use to redistribute routes from one routing domain to another routing domain.
■
Example
host1(config)# router bgp 100
host1(config-router)# neighbor 192.56.10.2 remote-as 200
host1(config-router)# redistribute static
host1(config-router)# exit
host1(config)# ip route 155.30.0.0 0.0.255.255
■
Use the no version to end redistribution of information.
■
See redistribute.
Using Access Lists for PIM Join Filters
You can apply access lists to PIM sparse mode interfaces along with the ip pim
join-filter or ipv6 pim join-filter command to use the access lists as PIM sparse
mode join filters.
To configure PIM join filters:
Access Lists
■ 29
Chapter 1: Configuring Routing Policy