Juniper IP SERVICES - CONFIGURATION GUIDE V 11.1.X, Configuration Manual

Page: 223 / 366

■
Use the no version to remove all ANCP configurations.
■
See l2c.
Defining the ANCP Session Timeout
In L2C Configuration (config-l2c) mode, you can use the session-timeout command
to specify the ANCP session timeout value. The timer range is 1–25 seconds with a
default value of 25 seconds.
session-timeout
■
Use to define the ANCP session timeout value (in seconds).
■
Example
host1(config-l2c)# session-timeout 10
■
Use the no version to revert the session timeout to its default setting, 25 seconds.
■
See session-timeout.
Learning the Access Node Partition ID
In L2C Configuration (config-l2c) mode, you can use the wait-for-gsmp-syn command
to enable the learning option. This learning option in the virtual router enables
network access server to learn the partition ID from all the access nodes.
wait-for-gsmp-syn
Use to enable the learning option in ANCP.
■
■
Example
(config-l2c)# wait-for-gsmp-syn
■
Use the no version to disable the learning option in ANCP.
If the access node does not send the GSMP_SYN message after initiating the TCP
session, the connection is lost because the session timer expires. To avoid this, you
can use the
gsmp-syn-timeout command to specify the timeout value in L2C
Configuration (config-l2c) mode. The timer value cannot be more than the ANCP
session timeout value with a default value of 60 seconds.
gsmp-syn-timeout
Use to define the TCP session timeout value (in seconds).
■
■
Example
(config-l2c)# gsmp-syn-timeout 10
Configuring ANCP
■ 197
Chapter 7: Configuring ANCP