Juniper IDP 250, Installation Manual

Page: 33 / 68

Rack Mounting the IDP Sensor
„ 19
Chapter 3: Installing the Sensor
Figure 9: Rail with Hinged Rear Bracket
2. Rotate the hinges on both rails so that they allow the device to slide into the
rack.
3. Slide the chassis into a set of rails.
4. Secure the front brackets to the rack.
5. Rotate the rear brackets so they prevent the device from sliding forward.
6. Secure the rear brackets to the rack.
Mounting Using Midmount Brackets
To mount the sensor using the midmount brackets in a device rack:
1. Use a flathead screwdriver to attach one rack-mounting bracket to each side of
the chassis with the bracket screws. See Figure 10 and Figure 11.
Figure 10: 2 RU Device Midmount Bracket
CAUTION: Be sure to leave at least two inches of clearance on the sides of each
chassis for the cooling air inlet and exhaust ports.