Management Ports
13
Chapter 2: Hardware Overview
Peer Port Modulation
After peer port modulation (PPM) is enabled, the sensor deactivates all the
interfaces in that virtual router if the link goes down for any of the interfaces in a
virtual router. All devices connected to the virtual router will detect a port failure
and must be configured to take appropriate action.
You cannot enable NIC bypass and PPM on the same sensor. On the IDP 75, 250,
800, and 8200 sensors:
PPM works on both copper and fiber interfaces.
PPM works by turning off appropriate interfaces. Because of this, interface
speeds can be set to auto on the sensor and on attached switches.
Management Ports
These ports are provided on all IDP sensors.
Console Serial Port
The console serial port provides access, using an RJ-45 connector, to the sensor’s
command-line interface (CLI).
Management Port
The management port provides access to the ACM to the sensor through
10/100/1000 Mbps Ethernet. The ACM is accessed from the management port and
entering the correct URL in a browser window (
https://
SensorIPAddress
)
.
Hard Drives and USB Ports
Table 5 describes the hard drives and USB ports available on each sensor.
Power Supplies
Table 6 describes the types of power supplies available on each sensor.
NOTE:
Although both the console serial port and the management port use RJ-45
connectors, do not plug the network cable into the console serial port.
Table 5: IDP Sensor Drives
IDP Sensor
Drives
75, 250
One USB port
One internal hard drive
800, 8200
One USB port
Two externally accessible, hot-swappable, RAID-1
mirrored hard drives
Summary of Contents for IDP 250
