Juniper HarvestMaster GRAINGAGE H2 STATIONARY, User Manual

Page: 31 / 95

H2 Stationary GrainGage User’s Guide
31 Mirus and H2 Stationary GrainGage Setup
The following table displays the typical preferred setting for each item on this screen.
System Settings
Item Default Value Description
Debug Streaming
Enabled
No
This enables debug streaming messages for the DSP
module . Enabling this is only recommended when
troubleshooting the GrainGage with a HarvestMaster
Field Service Engineer .
GrainGage Type Stationary Designates which GrainGage type is connected to Mirus .
Isolation Gate
Mode
Normally Open
Not used with the H2 Stationary GrainGage .
Controls the initial state of the isolation gate . In some
situations, closed is preferred .
2.3.8 Reset the H2 Stationary GrainGage to Factory Settings
This option can be found on the
Setup
>
H2 GrainGage
>
Factory Reset
screen.
CAUTION: This cannot be undone! Resetting
the GrainGage to factory defaults will clear all
your settings, including actuator timers and
weight calibrations. This should only be done in
consultation with a HarvestMaster Field Service
Engineer.
!