H2 Stationary GrainGage User’s Guide
13
Introduction to the H2 Stationary GrainGage
1.2.1 Unpack the GrainGage
1. Use the folded legs of the GrainGage to lift it out of the
box.
2. Adjust the leg position by removing the leg pins and
rotating the legs down.
3. Align the pinhole in each leg with a cycle position hole
in the GrainGage.
4. Insert the leg pin for each leg.
5. Use the bubble level on top of the GrainGage to verify
the GrainGage is level and stable.
Leg pin
Cycle position holes
Legs
Bubble Level
Summary of Contents for HarvestMaster GRAINGAGE H2 STATIONARY
