A-29 Super Tucano 60TP 1.1 2022
45
Above: definitive position of the red LEDs on the back of the fuselage after internal fixing of the board.
To install the vertical stabilizer formation lights, precise cuts must be made in the places where they will be
fixed. To pass the boards to their installation locations, use a line to pull from the inside of the fuselage. Test
and check until they are well positioned and glue them with epoxy glue for 5 to 10 minutes.
Above: right side of the original vertical stabilizer without cuts (left), cuts on the left side of the vertical
stabilizer to allow the installation of formation lights (center) and LEDs properly installed (right).
To install the intercept headlight on the right side of the fuselage, a 20mm hole must be drilled in the front
part of the fuselage, where there is a marking to accommodate the headlight. Test and check until it is well
positioned and glue it with 5 to 10 minutes epoxy glue.
Above: position of the intercept headlight on the front right side of the fuselage.
