A-29 Super Tucano 60TP 1.1 2022
26
Above: servos fixation bases location on wing´s ribs. Aileron (left) and flap (right).
To pass the servo extensions inside the wing, position it with the tip upwards and insert a thread with a
weight tied at the end through the aileron servo box, passing through the hole in the wing spar to the leading
edge until exit through the front hole of the wing root. Connect the extensions to the servos (aileron and flap)
and lock the connectors so that they do not come loose in any situation. Tie the end of the aileron servo
extension to the end of the thread in the aileron servo box and carefully pull the connector to the wing root.
Attach the outer tip of the extension to the root of the wing with adhesive tape. Repeat the same process for
the flap servo extension. Repeat the same process for the other half of the wing.
Above: thread and extensions passing process on wing with the servos.
Before definitively screwing the servos, apply a drop of medium CA glue or 5 minutes epoxy glue to each hole
in the ribs where they will be fixed. To screw the flap and aileron servos onto the internal ribs of the wing, use
a short screwdriver to keep the screw angle at 90º in relation to the ribs, as there is little internal space. It is
necessary to open a slot on the servo compartments covers to pass the servo arms as shown in the photos. To
fix the servo compartment covers, apply a drop of medium CA glue or 5 minutes epoxy glue in each hole for
better fixation and resistance to vibration.
