o
Connect the luminaire to the new transmitter, see chapter 4.2.
4.2 Connecting a luminaire to a transmitter
o
Press the
Ɔ
and
ƌ
buttons simultaneously until the LED flashes green.
The luminaire flashes briefly. Connection in process.
LED on the transmitter lights up green. Luminaire lights up green or flashes twice. Connec-
tion has been set up successfully.
LED on the transmitter flashes red quickly for 3 seconds. Could not set up connection.
i
In case of error, if the distance between the devices is too big or the luminaire already
belongs to an existing network, see Chapter 4.5.
Alternatively, all memory locations in the transmitter are occupied. In this case, delete all
connections to luminaires that are not needed, see Chapter 4.6.
4.3 Adding the transmitter to an existing network
i
If the transmitter already belongs to a network, reset it beforehand, see Chapter 4.7.
Prerequisite:
At least one luminaire must be switched on.
o
Press
Ƌ
and
ƍ
buttons on the new transmitter simultaneously until the LED flashes
green.
The new transmitter is in programming mode.
o
Within 10 seconds, start a connection process on a transmitter from the existing network
(see Chapter 4.2 or the manual of the respective transmitter).
7/15
ZigBee radio hand-held transmitter
82595215
J0082595215
28.06.2017
