o
Within 2 minutes after the last button has been pressed, transfer the buffer memory to the
desired transmitter, see Chapter 5.5.
5.5 Passing connections from the buffer memory to a transmitter
o
Put the receiving transmitter in programming mode, see Chapter 4.3.
o
Start a connection process on the sending transmitter by pressing the
Ɔ
and
ƌ
but-
tons simultaneously until the LED flashes green.
The connections are passed from the buffer memory to the receiving transmitter.
LED lights up green for 3 seconds. The connections from the buffer memory have been
passed on.
LED flashes red quickly for 3 seconds. The connections from the buffer memory have not
been passed on.
6 6 Updating the device software
The device software is updated via radio. This requires a separately available supplemental
device. Refer to the manual of the supplemental module.
Prerequisite 1:
The supplemental device must belong to the network of the transmitter.
Prerequisite 2:
The transmitter must not be in the default setting.
o
Press the
Ƌ
and
ƍ
buttons simultaneously until the LED flashes green.
13/15
ZigBee radio hand-held transmitter
82595215
J0082595215
28.06.2017
