JUMO AQUIS touch P, Interface Description

Page: 36 / 52

6 Project planning
36
7. Set the startup parameters in the project structure of the IO controllers correctly. Pay attention in par-
ticular to the settings for the byte sequence for cyclical and noncyclical data. The byte sequence to
be set is specified by the IO controller. Please refer to the documentation for your IO controller.
8. The IO data of the JUMO IO device are now available for the programming of the IO controller. To
localize the IO data configured in the JUMO field device, refer to the printed module configuration
list. During program, the assignment of the device data to the IO items of the modules can be taken
from this list.
6.2 Configuring PROFINET modules
For project configuration in the engineering system of your PROFINET IO controller, you can populate
all slots with modules apart from Slot 1 on your JUMO IO device. Slot 1 is permanently assigned with the
immovable "DeviceStatusBlock" module. You can create additional modules for various data types via
the JUMO PC setup program for the field device concerned and configure their contents to suit your
needs. During this process, the selectable IO data in a module are filtered by data type suitable for the
module type. An overview of the module types can be found in the "Module description" chapter.
The placeholders in the respective module can be assigned data from the selectors of the JUMO field
device and be provided with a comment. In other words, the content of the configurable modules can be
determined by the user. In the project configuration of the IO controller, the modules have to be assigned
to the free slots in the JUMO IO device.
Once the configuration has been created by means of the JUMO PC setup program and loaded into the
field device, the PROFINET configuration can be printed. The printout contains an overview of the com-
plete module configuration of the JUMO field device with all IO data, which the field devices provisions
for the PROFINET IO communication. In the engineering system, the modules must then be assigned
to the slots in the JUMO IO device, so that they can be queried by the IO controller during the cyclical
communication.
NOTE!
Make sure that your JUMO IO device has the software version required to use PROFINET IO (see
chapter 2.3 "Requirements for hardware, software, and cabling", page 7). The PROFINET configuration
in the JUMO setup program of your device is available only for device software versions that are com-
patible with PROFINET IO.