Initial operation
44
3. Screw the hoses onto the pump connectors by hand.
Pay attention to the supply and runback position.
4. Screw on the pump connections carefully with a maximum of 3 Nm torque.
The external system is connected.
If the external system is disassembled, the pump connections must be
resealed with the sealing plugs so that no bath fluid can splash out during
operation.
7.3.2 Connect an external system with barbed fittings
This section describes how to connect an external, closed system to the device
using barbed fittings.
Open-end wrench, 17 mm
Open-end wrench, 19 mm
Barbed fittings are available for installation of the external system.
1. Disassemble the union nuts on the pump connectors.
2. Remove the sealing plugs.
3. Push one barbed fitting through each of the union nuts.
Summary of Contents for Magio MX
Page 100: ......
