-
6
-
(2) How to Pack
a.
Packing the Center part
1) Roll up the air cap w hich is to be crashed easily w hen the board w idth is set
to the
minimum
value (30 mm), then put it into the center part.
2) Adjust the board transport width to the minimum value (30 mm), and paste
filament tapes approximately in the middle of the screw shaft and the guide
shaft (two positions) (see Figures 1-1 and 2-1).
Figure2.1
Make sure that the rail plate (black part) receives no load. If the rail
plate is deformed, the machine cannot operate normally.
b. Right And Left Edges
1) Put air cap which can be crashed easily into the protruded parts from the main
unit.
2) Wrap the air cap around the protruded parts as indicated in Figure 2-2.
Figure3.2
Make sure that the rail plate (black part) receives no load. If the rail
plate is deformed, the machine cannot operate.
*Note that the air cap should not
touch any sensor.
Move these plates until the board
transport width becomes the
minimum value (30 mm).
Filament tapes (two positions)
Air cap
300
Rail plate F
Rail plate M
Filament tapes
CAUTION
!
CAUTION
!
w
q
e
