– 5 –
175mm
❸
❶
❷
A
D, E
AMS-224EN-4530
AMS-224EN-6030
* The following steps 3) through 7) are the re-as-
sembly procedure of the table.
3) Shift the table to adjust so that it laterally pro-
trudes from the end of the table stand by 175
mm. For the longitudinal direction, also adjust so
that the table protrudes equally (approximately 3
mm on each side) from the end of table stand.
* If the table is not correctly positioned in the
longitudinal direction, the throat plate auxiliary
cover may not be removed.
4) Temporarily fix table fixing bolts
❸
at two loca-
tions from the table stand side.
5) Tighten screws
❶
and
❷
to mount the cover.
* If the cover and tapped hole do not align, align them
by moving the table.
* Tighten screw
❷
after mounting the nut from the
underside of the table.
6) Securely tighten the table fixing bolts at two
locations from the table stand side. (For refer-
ence: Tightening torque: 6 N•m)
7) After mounting the cover, attach the table fixing
bolt cover (accessory
A
) in position.
9) Secure the operation panel stoppers (accessory
D
) in the punched locations at near side of the
right table using wood screws (accessory
E
).
8) AMS-224EN-4530
Secure the switch mount-
ing plate on the table
stand using countersunk
head screw (accessory
B
). Then, fix the power
switch using sems screw.
AMS-224EN-6030
Secure the power switch
at the punched location
on the lower right part of
the table using female
screw (accessory
C
).
❸
2) Remove table fixing bolts
❸
which are mounted
at two locations of the table stand.
B
C
