Page 21/27
The Quality Connection
7. Trouble Shooting
-1
n or stop
,
7
When dial does not tur
nd each block are not assembled corr
•
Crimper, spacer a
foreign matters, e
ectly due to slant, adhesion of
104)
g (No.107)
o.144)
cam roller (No.124) and
of pressure plate (No.141)
t and adhesion of foreign matters such as waste, dust, paper,
)
arrow) of guide plates (L) (No.151) and (R) (No.150)
not cut well due to abrasion. Check shear blade supporter
by
w, roughness, peeling off of plating, etc.
rrect position, coming off, etc. of stripper (No.147)
ide plates (L) (No.151) and (R) (No.150)
Insufficient pressure of pressure plate (No.141)
•
Bolts holding the feed plate (No.152) are not secure
tc.
•
Incorrect die hold ring is used. (Dimension is different.)
•
Defective
parts
Disk at wire conductor side (Dial: A
∼
H)
...Malfunction of positioning pin (No.105) and spring (No.
Disk at wire insulation side (Dial: 1
∼
8)
...Malfunction of steel ball (No.108) and sprin
l feeding
7-2
Dispersion or malfunction of termina
•
Improper stroke adjustment of feed finger (No.144)
(No.130)
•
Broken feed finger spring
•
Loosened fitting bolt of feed finger (N
•
Deformation, crack, breakage, abnormal abrasion, etc. of
cam roller shaft (No.125)
am (No.111)
•
Abnormal abrasion of c
•
Insufficient pressure strength
(Improper adjustmen
plating powder, etc.
7-3
Jamming of terminals
•
Incorrect adjustment (too n
•
Shear blade (No.158) does
(No.160) as well.
•
Deformation
of
terminal
7-4
It is difficult to remove the crimped terminal from the applicator after crimping
.
•
Abnormality of internal surface of crimper (A) (No.154) and (B) (No.156) caused
fla
•
Malfunction such as inco
7-5
Dispersion of bell-mouth
•
Incorrect adjustment such as excessive gap of gu
•
Incorrect mounting of crimper
•
Dispersion of feeding position
Bolt-holding feed finger (No.144) is not secure
