Page 15/27
The Quality Connection
6-4
Centering of crimper and crimper anvil
6-4-1
Lower slide (No.102) little by little and check the gaps on both right and left sides of
crimper and crimper anvil with loupe, etc. A white paper can be used in back to check
the gaps more easily.
6-4-2 When the gaps are not even on the right and left sides, loosen bolt on side block
(No.114) and adjust the gaps evenly on both the right and left sides and tighten the bolt
securely.
6-5
Gap between crimper (B) and shear blade
6-5-1 Check the gap between crimper (B) (No.156) and shear blade (No.158) lowering slide
(No.102) little by little. (Reference the die construction sheet for value of gap).
6-5-2 When the gap is not within reference value, loosen the bolt on the die block (No.112).
Move die block little by little to adjust the gap, and tighten bolt securely. The value of
gap will vary depending on terminal to be used.
