Page 12/27
The Quality Connection
6. Assembly and Adjustments
6-1.
Slide part
6-1-1
Assembly of slide part
Install each part so that the part number faces outward and can be seen. Wire disk
(No.109) and insulation disk (No.106) are attached by the shank (No.110). When
removing them, loosen the set bolt on the right side of slide (No. 102), and then
loosen shank (No.110). Tighten wire block (No.166), insulation block (No.167) and
block ring (No.168) with fitting bolt. Wire block and insulation block should have
movement in up and down directions.
6-1-2 Trouble
cases
(1) Dial does not turn smooth or not at all,
•
Caused by wire disk (No.109)
Positioning pin (No.105) and spring (No.104) do not work well due to rust, etc.
Wire block (No.166) and crimper (A) (No.154) are not assembled correctly due to
slanting, adhesion of foreign matters, etc.
•
Insulation disk (No.106)
Steel ball (No.108) and spring (No.107) are defective or excessively tightened.
Incorrect fitting of insulation block (No.167) and crimper (B) (No.156) due to
slanting, adhesion of foreign matters, etc.
(2)
Dial
does
not
stop,
•
Wire disk (No.109)
Broken spring (No.104) or broken positioning pin (No.105).
•
Insulation disk (No.106)
Steel ball (No.108) is missing; spring (No.107) is missing or damaged, etc.
