JRC JMA-7110-6XA, Instruction Manual

Page: 445 / 572

JMA-7100 Instruction Manual
>
9.TROUBLE SHOOTING AND AFTER-SALES SERVICE
>
9.1 FAULT FINDING
9
－
5
9
Table9-7 ： List of Conditions Messages
Message Class Description ALR No.
i
i. ALR No.: Unique alarm number in ALR sentence and ACK sentence
Battery Dead Warning The battery is dead.
Battery Low
Warning
battery is weakening.
GPS (HDOP)
Warning The HDOP level is increased (Decrease in the GPS
accuracy.).
MON Test
Warning
Performance monitor is active.
Scanner Rotating
Warning
The scanner is rotating (When transmitter is standby
state.).
Table9-8 ： List of Interswitch Alarms and Messages
Message Class Description ALR No.
i
i. ALR No.: Unique alarm number in ALR sentence and ACK sentence
Connection
Masked Note Inhibition of control / connection is set.
ISW (Data) Alarm No communication, data mismatched, or checksum error. 327
ISW Busy Note Access to the ISW menu was made during interswitching.
ISW Complete Note The switchover of the Interswitch ended normally.
ISW Error Note The interswitch is disabled.
ISW Standby Note The Interswitch recovered normally.
ISW Straight Note The interswitch is forced to change the connection
into straight.
ISW Time Out Note Failed in switching.
Master Range CHG Note The range of the own display unit has changed due
to change in the range of the master display unit.
Master Standby Note The master display unit does not transmit any
signals.
Pattern CHG Failed Note Connection change failed.
TXRX Standby Note The scanner unit is in the standby mode.
Update ISW
Software Note Tried to enter new TXRX function, when interswitch
software used old version.