JR ProPo ERGO .32, Assembly Instructions Manual

Page: 37 / 66

7-1
AILERON LINKAGES
7-2
ELEVATOR LINKAGE INSTALLATION
37
......... 1 pc
2x8mm Flat Head Screw
..........1 pc
Steel Joint Ball
.........1 pc
2mm Hex Nut
..........2pc
2x8mm Flat Head Screw
..........2pc
Steel Joint Ball
..........2pc
2mm Hex Nut
A Special Note To Beginners: It is suggested that the maximum travel
limits for aileron, elevator, pitch and rudder controls be reduced to 70%.
Note: Attach the steel joint ball to the correct hole as shown below:
Make sure the Aileron Trim is in the
center position before attaching the
Servo Arm to the Servo.
Be sure to remove the excess Servo Horn Arms as shown.
Secure the Servo Horn using the Servo Horn Screw.
Attach the Steel Joint Ball to the bottom side of the Servo Horn.
Make sure the Elevator Trim is in the center position
before attaching the Servo Arm to the Servo.
At this time, check to insure that the Swashplate is at
a 90° angle to the Main Rotor Shaft in both fore/aft
and right/left directions.
Be sure to remove the excess Servo Horn Arms as shown.
Secure the Servo Horn using the Servo Horn Screw.
Servo Reversing Directions
JR Normal
Futaba Normal
2x8mm Flat Head Screw
Steel Joint Ball
2mm Hex Nut
2.3x35mm All Threaded Rod
20mm
21mm
JR
Futaba
Use this Horn
Futaba
JR
10.5mm
Servo Horn Hole Selection
Right
Left
90˚
Servo Horn
2mm Hex Nut (2 pc)
Servo Horn (2 pc)
Steel Joint Ball (2 pc)
2x8mm Flat Head Screw (2 pc)
2.3x60mm All Threaded Rod
39mm
Servo Horn Hole Selection
Use This Hole
10.5mm 10.5mm
40mm
90˚
90˚
Down
Up
90˚
JR
Futaba
Futaba JR
Servo Reversing Directions
JR Normal
Futaba Normal