12
GB
POSITIONING SEATS IN THE VEHICLE
Foward facing
YES
Rearward facing
NO
Car belt with 2 points
NO
Car belt with 3 points
YES
Car passenger front seat
NO
On outer rear seat
YES
On centre rear seat
NO
1
2
The seats in the picture marked in black are suitable installation place
.
1 -Diagonal belt
2- Lap belt
IMPORTANT
The seat must be installed using the car safety belt is absolutely the abdomen and in the diagonal band.
This child car seat can not be placed on front passenger seat and rear middle seat.
Place the child car seat on the appropriate seat in the vehicle, facing forward.
It is not recommended to fit the child car seat into a front seat equipped with airbag. If you wish to fit the child
car seat in any seat protected by airbag, always refer to the vehicle instructions manual.
ASSEMBLING THE CAR SEAT
The car seat consists of three components: an adjustable headrest, a backrest and a booster.
To install the child seat, hook the handle at the bottom of the backrest to the two interlocking brackets of the
seat, pushing firmly until you hear a click, then lift the backrest vertically. Insert the headrest into the upper
recess of the backrest and push it downwards until you hear a click. The subsequent clicks are used to adjust
the headrest in height (fig.1/2).
USE FOR GROUP II – III (15 - 36 Kg)
Adjusting the height of the headrest.
Regularly check if the headrest is at a suitable height for your child. The height of the headrest is correct and
corresponds with the size of the baby when the child’s head rests comfortably in the middle ( fig.3).
You can adjust the height of the headrest by holding the backrest with one hand and pulling the headrest
upwards (or pushing it down) with the other, gripping the upper part. You will hear a “click” when it is positioned
at the desired height (fig. 4).
Summary of Contents for JC-1504 DISINVOLTO
Page 3: ...3...
