Jonsered FR 13, Workshop Manual

Page: 39 / 68

English –
37
6012-044
6012-045
6012-046
IMPORTANT INFORMATION
Make sure that the seal’s metal spring
strengthener is located on the side of the
seal facing the transmission before the
seal is fitted.
Repair Instructions
Seal Replacement, Outgoing Axles
• Place the seal on the shaft with the smooth side
up and press it carefully down.
• Use the thick end of a 1/4" extender to
carefully
tap the seal down until the top side of the seal is
level with the upper edge of the shaft housing.
Move the extender in a circle around the seal so
that it is evenly seated all the way around.
• Remove the insulation tape from the shaft and fit
the lower circlip and pulley with the six-edged
hub face up.
• Fit the fan and the washer and the upper circlip.
• Clean the outgoing axle and the area around the
seal from all dirt and rust.
• Insert a screwdriver between the seal and the
axle and pry off the seal from the axle housing
with a twisting motion.
IMPORTANT INFORMATION
Dirt must not enter the transmission since
this will shorten the transmission’s life.
• Wrap insulating tape around the outgoing axle
from the beginning of the key groove and out-
wards until even the threads of the circlip are
covered with tape. This is done to protect the
new seal from damage.
• Lubricate the axle and the inside of the new seal
with lubricant so that the seal slips on smoothly.
Remove the rear wheels. Remove the circlips and
pull the wheels out. Do not lose the key that sits
between the hub and the axle. Use the 506 57 00-1
puller if needed.
Remove the spacing tube and washer from the
wheel axle.
2
1
3