39
SWITCHING THE MACHINE OFF
To switch the machine off, first turn the ignition key to the LOCK position and wait for the message "LASER
LOCKED" to appear in the red box on the display. When this message appears, turn the ON/OFF selector
switch on the rear of the machine to OFF.
Remove the key if it is considered necessary to prevent other personnel from using the machine.
INSTALLATION
SWITCHING ON FOR THE FIRST TIME
CONTINUED
NOTE: If the seals affixed to the laser system by the manufacturer are removed or damaged in
any way, the warranty covering the entire welding system shall be considered null and void.
WARNING: Always turn the key to the LOCK position first when switching the welding machine off
to allow the microprocessor to discharge the capacitor bank.
Summary of Contents for 4910880
