John Lewis JLBIOS635, User Manual

Page: 68 / 84

A
A
3. Close the door until it is at an angle of
approximately 45°.
45°
4. Hold the door with one hand on each side and
pull it away from the appliance at an upwards
angle.
5. Put the door with the outer side down on a
soft cloth on a stable surface. This is to prevent
scratches.
6. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
1
2
B
Caution! Rough handling of
the glass, especially around
the edges of the front panel,
can cause the glass to break.
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top edge
one by one and pull them up out of the guide.
9. Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, do the above
steps in the opposite sequence. Install the
smaller panel first, then the larger and the door.
Warning! Make sure that the
glasses are inserted in the
correct position otherwise the
surface of the door may
overheat.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
Warning! Danger of
electrocution! Disconnect the
fuse before you replace the
lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The top lamp
1. Turn the lamp glass cover counterclockwise to
remove it.
Steam oven User Manual 68