72
5-37
5-38
A
B
5-34
5-39
5
1
2
3
4
5-32
Operation
•
Balance the wheel according to the readings.
Both weight minimisation and balancing are accomplished.
Message
E9
Message E9 means that at least one error occurred
during the minimisation cycle. Press the
STOP
key
(
5
)
to exit the minimisation program and repeat
minimisation if necessary.
Option 2:
Do not
turn the tyre over on the rim
•
Press the
FINE
key
(
3
)
.
The result is recalculated.
Reading
Un.7 - II
or
H0
appears
Option 3:
•
Press the
STOP
key
(
5
)
to exit the minimisation
program and return to the balancing program
The imbalance on the wheel is shown on the readout.
•
Balance the wheel according to the readings.
Reading
Un.7 - II
(
Fig. 5-37
)
Readjust tyre on the rim (the right display bars light
up permanently).
Option 1:
Readjust the tyre on the rim
(normal program)
•
Readjust the wheel according to the right direction
indicator and make a double mark on the right side
of the tyre exactly perpendicular to and above the
main shaft
(
Fig. 5-38
)
.
•
Remove the wheel from the machine.
•
Readjust the tyre on the rim until the double mark
coincides with the valve
(
Fig. 5-39
)
.
•
Clamp the wheel on the balancer and readjust it so
that the valve is exactly perpendicular to and above
the main shaft.
•
Press the
ENTER
key (
1
) to acquire the valve
position.
Reading
Un.8
appears
(
Fig. 5-34
)
.
•
Spinn the wheel
(START
) (check run).
If weight minimisation was carried out correctly
(according to the program cycle), the machine
automatically returns to the type of weight positioning
previously selected and indicates the residual dynamic
imbalance on the wheel.
•
Balance the wheel according to the readings.
Both weight minimisation and balancing are
accomplished.
Message
E9
Message E9 means that at least one error occurred
during the minimisation cycle. Press the
STOP
key
(
5
) to exit the minimisation program and repeat
minimisation if necessary.
