exceed 50% at a maximum temperature of +40 ˚C, higher relative humidity may be permitted at lower temperature (e.
g. 90%@ 20 ˚C).
Floor Load
This machine represents a moderately large weight load in a small footprint. Most commercial shop floors will be
adequate for the weight of the machine. Some floors may require additional support. Contact an architect or structural
engineer if you have any question about the ability of your floor to handle the weight.
To
ensure
sufficient
upright
stability
of
the
machine
it
should
be
bolted
to
floor
.
For
this
purpose
4
holes
are
provided
in
the
machine
'
s
bracket
of
workstand
.
Working Clearances
Working clearances can be thought of as the distances between machines and obstacles that allow safe operation of
every machine without limitation. Consider existing and anticipated machine needs, size of material to be processed
through each machine, and space for auxiliary stands and/or work tables. Also consider the relative position of each
machine to one another for efficient material handling. Be sure to allow yourself sufficient room to safely run your
machines in any foreseeable operation.
Consider existing and anticipated needs, size of material to be processed through each machine, and space for
auxiliary stands, work tables or other machinery when establishing a location for your saw. See above figure for the
maximum working clearances of the Sliding Panel Saw.
Lighting and Outlets
Lighting should be bright enough to eliminate shadow and prevent eye strain. Electrical circuits should be dedicated
or large enough to handle combined motor amp loads. Outlets should be located near each machine so power or
extension cords are not obstructing high-traffic areas. Be sure to observe local electrical codes for proper installation
of new lighting, outlets, or circuits.
Dust Collector
As a rule, this machine must be vacuumed during use. A time relayed socket is available as an accessory. In addition,
the vacuum performance must be sufficient to achieve the required negative pressures and a maximum air speed of
20m/sec at the connector.
Read the manual before assembly and operation. Become familiar with the machine and it's operation before
beginning any work. Serious personal injury may result if safety or operational information is not understood
or followed.