Adjust the sliding panel level
1 .Place a level rule (cross cut fence) on to major table and sliding panel.
2.Loosen 4-M8x25 hex screws
(A)
, adjust the M8x40 hex screw
(B)
to adjust the sliding panel level.
3.Then re-tighten 4-M8x25 hex screws
(A)
.
4.To fine adjust, using 3 mm "L" wrench to adjust 4- M8x12 set screws
(C)
.
Install the push handle and lock pin
1 . Sliding the M12x1.75 T-nut into the sliding panel and thread in push handle
(D)
with a 17 mm open end
wrench.
2. Insert the star-type lock pin
(E)
into sliding panel, and lock the M10 hex nut on the opposite side.
Install the cross cut table
1.Slide two M8x70 carriage bolts with T-lblocks into the side slot of sliding panel. Attached the crosscut
table to sliding panel.
2.Use 2 wing nuts mounted the cross cut table to sliding panel.
3 .Use 2 M6x30 Hex head scews mounted the cross cut table to support
(B)
.
4 .Adjust 4-M12 thin hex nut
(C)
to adjust the cross cut table on the line with sliding panel.
4. 5.Then tighten 4-M12 thin nut
(C)
.
Install the hold down/Mitre Gauge
1. Slide the hold down/Mitre Gauge onto the sliding table and push it as far as possible. And lock the hold
down
/
mitre gauge on table with the star-type lock handle (A) locked.
2. Aligned the Mitre Gauge fence on it.