Worn switch.
Worn or damaged blade.
Worn or damaged blade guard.
V-Belts
To ensure optimum power transmission from the motor to the blade and to the hydraulic pump, the V-belts must be in
good condition (free from cracks, fraying and wear) and operate under proper tension. Check the V- belts at least
Replace the belts, if needed.
Bearings
The bearings are sealed and pre-lubricated and require no lubrication during their usable life. However, your saw
components will operate at their best if the bearing surfaces are kept clean this is especially important for the trunnion
bearings.
There is thermo cut-out inside the motor, this device protect the motor from being damaged in high
condition. When the motor's temperature
ELECTRICAL
Main switch
This machine is equipped with a knee touch no-volt release main switch and a limit switch.
The main switch is equipped a large size touch panel, during performance cutting work, any part of man body touched
the switch panel, it can bring the saw stop.
Limit switch
every 3 months; more often if the saw is used daily.
is too high the fuse will shut off
automatically.
you should check the reasons to cause the high temperature or be carried out by qualified specialists at once.
The thermo cut-out will return to normal automatically once the temperature low down.
temterature's
The limit switch is mounted under the inner guard, if your make scoring blade or main blade replacement,
remove the inner guards, the limit switch keep "off" position. Reduce the risk of unintentional starting.