Install dust hoses
1. Install the 2" dust hose onto the blade guard with 2" hose clamp.
2. Put the 2" dust hose onto dust hose support, keep free with the working table.
3. Another end of 2" dust hose clamps to the main dust port on the bottom of rear panel.
5. Install 4" dust hose to main dust port with 4" hose clamp
REPLACEMENT & ADJUSTMENT
Replace the main blade, d
isconnect the saw from the power source!
The main blade dimension suitable for
the
machine is 254x30x3( outer diameter, core diameter, thickness).
But any time you change blade thickness, the appropriate sized riving knife and scoring blade must also be
changed to match the size of main blade you install.
To change main blade:
1
.
Move the blade tilt to 0˚ (Blade 90˚ to table) on the control panel and raise the blade as far as it will go.
2
.
Move the sliding panel all the way to the right and remove two M6x12 pan head screws to expose the internal
blade guard that covers the blades and riving knife.
3
.
Remove the blade guard from the riving knife to expose the mounting assembly.
4
.
Remove the table insert.
5
.
Insert the arbor pin into the hole on blade inner flange and locks the blade.
6
.
Using the arbor wrench, remove the arbor nut that secures the main blade (turn clockwise to loosen).
7
.
Remove the arbor flange and the old main blade.
8
.
Install the new main blade, replace the arbor flange and nut, and tighten the arbor nut to secure the main blade.
9
.
Make sure the correct size riving knife is installed and aligned with the blade.
10
.
Move the internal blade guard back into its original position, next to the blades, and center the sliding panel.
If you change blade diameter sizes during this procedure, now is the time to adjust the riving knife.
If the kerf thickness is different from your old blade, the scoring blade kerf and riving knife thickness must match the
new main blade kerf.