3.Position the flip stop according to the length of the workpiece you want to cut off to the left of the blade.
Note
If the workpiece extends to the left of the saw blade more than 1200mm, then the crosscut fence slide needs to
be extended.
4.
Load the workpiece onto the table saw.
5.
Mount the hold down arm onto the stud and lock the work-piece in place.
6.
Once all the necessary safety precautions have been taken, perform the cutting operation.
To perform a miter cut using the hold down w/ mitre gauge:
1.
Mount the hold down onto sliding panel and fit a cut fence.
2.
Position the hold down w/mitre gauge at the desired angle and use the ratchet lever to lock the mitre gauge in
position.
3.
Load the workpiece onto the sliding panel. Secure the workpiece with clamp.
4.
Once all the necessary safety precautions have been taken, perform the cutting operation.
MAINTENANCE
Always disconnect power to the machine before performing maintenance. Failure to do this may result in
serious personal injury.
Cleaning
Cleaning the sliding panel saw is relatively easy. Vacuum excess wood chips and sawdust, and wipe off the remaining
dust with a dry cloth. If any resin has built up, use a resin dissolving cleaner to remove it. Treat all cast iron and
unpainted steel with a non-staining lubricant after cleaning.
Once a week:
Clean sliding panel surface and grooves.
Clean the cast iron or steel plate saw table.
Clean the roller guide ways for the sliding table.
Clean the aluminum rip fence and sliding grooves.
Clean the rip fence bracket.
Once a month:
Vacuum inside the motor cabinet.
Miscellaneous
Always be aware of the condition of your machine. Routinely check the condition of the following items and repair or
replace as necessary:
Loose mounting bolts.